|The Model WD-1RX is designed to process ribbon cable or multiple cables up to 2.7 |
inches (68 mm) wide. The cable is loaded into the right side of the laser work
area. A foot switch or electronic signal initiates the movement of the laser focusing
heads across the width of the parallel wires by moving in and out from the
front panel. Tooling can be used to batch process many parallel individual wires
at the same time.
The machine contains the laser, optical system, control electronics, power suppliers,
and mechanical components. Equipment water cooling is provided by the C-300
water cooler. Air exhaust, if not available on site, can be provided by the optional
ACS-2 air cleaning system.
Please use contact form for send message directly to seller. Your message will be sent directly to the recipient and will not be publicly displayed.